4L60E Transmission Fluid And Filter Change

4L60E Transmission Fluid And Filter Change. The pump is broken if the liquid levels do not. Measure how many quarts of dirty fluid came out.

How To 4l60e Transmission Flush/Filter Change Chevy Truck Forum from www.gmfullsize.com

The fluid capacity is based on the transmission stock with a shallow transmission pan and 12’’ torque converter. Well i dropped the tranny pan and changed the filter and some of the fluid today. If you need to look at purchasing a replacement 4l60e transmission there are lots available online.

Source: www.gmfullsize.com

Next, replace the rear torx screw on the shift linkage bracket and tighten the front one. Torque bolts in 3 steps.

Source: www.youtube.com

Overtime however, dex iii was phased out and gm released dex vi in 2005. While dex 6 is designed for newer vehicles and transmissions, it is backwards.

Source: www.1aauto.com

Replace the remaining bolts and get them finger tight. Does anyone have any ideas why after changing my oil filter dip tube o ring (which requires pulling the transfer case) in my 2011 chevrolet silverado 1500 4×4 5.3.

Source: www.youtube.com

I had some time off from work today, so i decided to change the transmission fluid and filter in my 2003 trailblazer that currently has about 130k miles on it. Torque bolts in 3 steps.

Source: tutors-tips.blogspot.com

Jack transmission up, remove the 1.25 inch block and lower it. It is pretty much the same for all 700r4, 4l60e, 4l65e and 4l70es.

Source: ls1tech.com

Total fill for the 4 speed 4l60e is 11.0 quarts. Use a couple of bolts to orient the new gasket and secure the pan back to the trans.

Source: www.youtube.com

Torque bolts in 3 steps. Depending on your vehicle, it can actually be a simple and straight forw.

Source: tutors-tips.blogspot.com

Watch the tube until you see bubbles or hear a bubbling sound and immediately shut the truck off. Does anyone have any ideas why after changing my oil filter dip tube o ring (which requires pulling the transfer case) in my 2011 chevrolet silverado 1500 4×4 5.3.

Source: tutors-tips.blogspot.com

Total loss of fluid or pump failure could be the cause of 4l60e transmission problems. Replace the remaining bolts and get them finger tight.

Source: tutors-tips.blogspot.com

Assuming i do it myself, i can purchase a acdelco 24208576 professional automatic transmission fluid filter kit on amazon for about $28, but that kit said notes: In 20 seconds you can become part of the worlds largest and oldest community discussing general motors, chevrolet and gmc branded pickups, crossovers, and suvs.

Source: www.gmfullsize.com

This is a 2000 t/a with 66k on her and i believe this was the first time the filter and fluid have been changed. If you need to look at purchasing a replacement 4l60e transmission there are lots available online.

Source: tutors-tips.blogspot.com

Well i dropped the tranny pan and changed the filter and some of the fluid today. It is pretty much the same for all 700r4, 4l60e, 4l65e and 4l70es.

Source: www.youtube.com

Gen iii and iv small block & drivetrain. Depending on your vehicle, it can actually be a simple and straight forw.

Source: www.gmtruckclub.com

The filters we recommend for your 4l60e are:. The fluid capacity is based on the transmission stock with a shallow transmission pan and 12’’ torque converter.

Source: www.gmfullsize.com

Gen iii and iv small block & drivetrain. Next, replace the rear torx screw on the shift linkage bracket and tighten the front one.

Source: www.youtube.com

In 20 seconds you can become part of the worlds largest and oldest community discussing general motors, chevrolet and gmc branded pickups, crossovers, and suvs. The extra gear gave the 4l60 more torque multiplication than any of its competitors in its time.

Source: www.gmfullsize.com

Dropped the pan, and let it drain over night. Remove the old gasket and clean the pan and magnet.

Source: www.primagem.org

Checking tranny fluid (4l60e) sign up for free! The pump is broken if the liquid levels do not.

Source: blazerforum.com

Transmission filters for the 4l60e are very inexpensive and simple. Gen iii and iv small block & drivetrain.

Source: tutors-tips.blogspot.com

50, 80 and 100 inch lbs. Drain the fluid if there is a drain plug.

Total Loss Of Fluid Or Pump Failure Could Be The Cause Of 4L60E Transmission Problems.

This is a 2000 t/a with 66k on her and i believe this was the first time the filter and fluid have been changed. Use a couple of bolts to orient the new gasket and secure the pan back to the trans. Added fluid based on the haynes manual (and several other sites) suggested fluid and filter change recommending 5 quarts.

Measure How Many Quarts Of Dirty Fluid Came Out.

50, 80 and 100 inch lbs. This is a identical process in the gmc. Transmission filters for the 4l60e are very inexpensive and simple.

While Dex 6 Is Designed For Newer Vehicles And Transmissions, It Is Backwards.

The extra gear gave the 4l60 more torque multiplication than any of its competitors in its time. I would be less than happy mid change to find out i have the wrong one. That is one of the reasons your 4l60e lost all gears.

Well I Dropped The Tranny Pan And Changed The Filter And Some Of The Fluid Today.

Replace the remaining bolts and get them finger tight. Jack transmission up, remove the 1.25 inch block and lower it. In this video we show how to change the transmission fluid and filter on pete's 4l60e.

The Fluid Capacity Of The 4L60E Transmission Is 6.5 Quarts With A Filter Change.

It was certainly due and i wanted to share some pictures with you. It weighs 146 lbs before transmission fluid is added and 162 lbs with it. I had some time off from work today, so i decided to change the transmission fluid and filter in my 2003 trailblazer that currently has about 130k miles on it.

Location:

Share :